Forum

***xavi*** · (This post was last modified: 08-02-2014 05:41 AM by xavi.)

Chronojump 1.4.7 has been published! (2014-Aug-1)

Download here:

Encoder changes

Signal is called "set", and curve "repetition
On encoder, when capture is done, best repetition is saved automatically (following criteria of best mean power on concentric phase). Can be changed on preferences to save all or save none of the repetitions.
Changed Neuromuscular Profile, now uses ecc-con phase (not ecc-con-ecc-con as before), and can be used on current set and on saved repetitions. Only needs three jumps to work.
Inertia moment calculation now calculates also the inertia moment of the different weights attached.

Jumps, runs changes

On capture, jumps, runs result is now show on bold to distinguish from other numbers
When executing a test, timer on screen is always ok. Before results where ok, but realtime chronometer on the screen on contacts execution had a bit of lag. Now is solved.
Added split times on interval runs results
Added new method to calcule DjPower on jumps (added to results and to statistics)
Added RSA RAST test
Elasticity Index, Arms Using Index, IRna and IRa now calculated by default using heights (not flight times). User can change it on preferences and leave it as before if desired.
RSA tests cannot be simulated now (can only be done using Chronopic)
When Chronopic gets disconnected, next test is managed as simulated without crashing the software

Other changes

On preferences, translatable graphs option affects now on encoder and on the rest of the tests (before was only on encoder)
Better Chronopic-Firmwarecord, now it's easy to access to the firmwares and the problems on loading a firmware are gone.
Added Troubleshooting guide (See manual folder)
Updated manual
Press 1,2,3,4 on start to select mode: Jumps, Runs, Encoder or Other
Updated Spanish and Czech translations
Minor fixes